Wiggle Fingerless Mitts
Yarn: Worsted weight and soft. I used Berroco Ultra Alpaca. It took much less than one skein.
Needles: Size 6 dpns.
CO 44 sts an join rnd, careful not to twist
R1: (p1, k4) 4 times. p1. work in 1x1 rib, starting with a knit st, to the end of the round. Repeat this rnd 1 more time.
R3: ( p1,C4B, p1, k4) 2x. p1. work in 1x1 rib, starting with a knit st, to the end of the round.
R4: work the same as rnd 1.
R5: Work in cable panel pattern as follows:
1: (p1, k4, p1, C4F) 2x. p1. work rest of round in stockinette.
2: (p1, k4) 4 times. p1. work rest of round in stockinette.
3: (p1, C4B, p1, k4) 2x. p1. work rest of round in stockinette.
4: work same as round 2
Repeat these 4 rounds until you're ready to place the thumb. for me, that was at 4 inches.
Thumb: For the right hand, work across the cable panel. K2. Using waste yarn, k7; slip these sts back to left needle and k them again using working yarn. Continue working the rest of the round in pattern.
For the left hand, work the round you're on until 9 sts remain on the left needle. Using waste yarn, k7; slip these sts back to left needle and k them again using working yarn. K2.
After setting up to make the thumb, work in pattern for another 2 inches and BO. Almost done!
Finish the Thumb:
Remove the waste yarn and place resulting live sts on two double-point needles. There will be 7 sts below the opening and 6 sts above. Attach yarn and k the 7 sts on lower needle; using a second needle, pick up and k 2 sts (I wrap the picked up sts. to help avoid holes) in the space between the upper and lower needle, k first 3 sts from upper needle; using a third needle, k remaining 3 sts from upper needle and pick up (and wrap, if desired) and k 2 sts in space between this needle and lower needle. 17 sts.
K 4 rounds. BO and weave in ends.
Ta Da!
This is the first time I've ever written a pattern out, so please send me any corrections!