Scrappy Crochet Bear Pattern

Scrappy Crochet Bear

Supplies
Approximately 9 grams of worsted weight scrap yarn
size G/ 4.25 mm crochet hook
notions to make the face
stuffing
yarn needle

Start with the body, since it is the largest piece.
Body
Ch 60 in body color, work flat in sc until the piece measures about 3.5 inches. This will be the face. Switch to the scraps and continue to sc until the total piece measures 9 inches, changing colors and striping as you wish. Finished piece will measure approx. 14" x 9".

Arms
Ch 20 using the same color as the face. Join into a ring with a slip st and work in sc for half an inch. Switch to using scraps, changing colors and striping s you wish, until the arm measures 3 inches. Make 2.
Legs
Ch 25 (at this point, you may be out of face color. I used the same color to start each leg to give the impression of shoes) Join into a ring with a slip st and work in sc for 1 inch. Switch to your scraps, striping as you wish, until the leg measures 4.5 inches.
Ears
Using whatever colors you have left, Ch 2.
Round 1 - 6 dc into 2nd chain from hook. Join with a slip st into 1st dc.
Round 2 - switch colors, 1 ch, 2 dc into same stitch as chain, {2 dc into next dc} 5 times. Sl st into 1st dc.
Round 3 - switch colors, 1 ch, 2 dc into same stitch as chain, {2 dc into next dc} 10 times. Fasten off and weave in ends.
Finishing and Assembly
For the arms and legs, turn inside out and center the color jogs (think of this as a back seam) Tie off or weave in the ends, press flat and then stitch the end that is the hand or foot closed. Leave the other end open. Lightly stuff the arms and legs.

Add the Face


For the body, find the center of the rectangle and add the face. You can use safety eyes, felt, embroidery floss, whatever you have handy.

Add the Arms


Then fold the edges to the center and mark where the sides are. Lay it out flat again and stitch the arms on (arms should be lightly stuffed).

Add the Legs

Fold right sides together and sew the back seam closed. Center the back seam and then tuck the legs inside the body (legs should already be stuffed), aligning the open edge of the leg with the bottom edge of the body. Pin in place and sew closed.
Turn right side out.

Add Ears and Close
Stuff the body to the desired firmness. Sandwich the first ear between the front and back sides and stitch closed, being careful to pass through all three layers of fabric. Stitch the top middle of the head closed and then add the second ear as the first.

Enjoy your new toy!

Cuddlefish, aka Nautie from Knitty

Pattern: Nautie from Knitty.com (free!)
Yarn: O-wool Balance (in my top 5 favorite yarns of all time!)
Needles: size 6
Made for: My baby-to-be (about a month away!)

This was a fun and weird knit. I like making toys...there's also a Mr. Dangly 2.0 waiting in the wings for his photo shoot.
I don't have all that much to say about this project. It wasn't boring, wasn't too hard, and make people laugh. All in all a good deal. Also, my poor future son will realize that that his mom has always been a little odd early on. : )

Hopefully I will get my other creations blogged about and current projects finished before d-day. Only a month left!

Colorless Green Mitts Breed Furiously

I made these immediately after Fetching, but it's taken me a good long while to write this up. I made up this pattern sitting bored at school one day and I'm very happy with the results. I thought I would share it. It takes very little yarn, is quick, and could be a good gift knit. so, here ya go:

Wiggle Fingerless Mitts

Yarn: Worsted weight and soft. I used Berroco Ultra Alpaca. It took much less than one skein.
Needles: Size 6 dpns.

CO 44 sts an join rnd, careful not to twist
R1: (p1, k4) 4 times. p1. work in 1x1 rib, starting with a knit st, to the end of the round. Repeat this rnd 1 more time.

R3: ( p1,C4B, p1, k4) 2x. p1. work in 1x1 rib, starting with a knit st, to the end of the round.
R4: work the same as rnd 1.

R5: Work in cable panel pattern as follows:

1: (p1, k4, p1, C4F) 2x. p1. work rest of round in stockinette.
2: (p1, k4) 4 times. p1. work rest of round in stockinette.
3: (p1, C4B, p1, k4) 2x. p1. work rest of round in stockinette.
4: work same as round 2


Repeat these 4 rounds until you're ready to place the thumb. for me, that was at 4 inches.

Thumb: For the right hand, work across the cable panel. K2. Using waste yarn, k7; slip these sts back to left needle and k them again using working yarn. Continue working the rest of the round in pattern.

For the left hand, work the round you're on until 9 sts remain on the left needle. Using waste yarn, k7; slip these sts back to left needle and k them again using working yarn. K2.

After setting up to make the thumb, work in pattern for another 2 inches and BO. Almost done!

Finish the Thumb:
Remove the waste yarn and place resulting live sts on two double-point needles. There will be 7 sts below the opening and 6 sts above. Attach yarn and k the 7 sts on lower needle; using a second needle, pick up and k 2 sts (I wrap the picked up sts. to help avoid holes) in the space between the upper and lower needle, k first 3 sts from upper needle; using a third needle, k remaining 3 sts from upper needle and pick up (and wrap, if desired) and k 2 sts in space between this needle and lower needle. 17 sts.

K 4 rounds. BO and weave in ends.

Ta Da!

This is the first time I've ever written a pattern out, so please send me any corrections!

It's Cold!

It officially got chilly yesterday. Time to get serious about the knitting. I'm working on another small project but sweater weather demands, well, a sweater. But which one? I've got four in mind. While I typically reside in a reality of my own design, I'm not delusional. I know I'm not going to make more than one. I might not even finish one. But, in my own reality I will, so I need to get going. Anyway!

Here are the contenders:

*The Minimalist*

Pros: I have the pattern, it's stylish, and looks really wearable.
Cons: It's a LOT of seed stitch

*Midnight Circular*

Pros: The back looks really neat and it's constructed in an unusual way.
Cons: I have to buy the pattern. Not entirely sure I would wear it.

*Modern Lace Henley*

Pros: The pattern is free. The lace looks interesting, and it seems to have a high amount of wearability.
Cons: It's listed as "Piquant" on Kinnty, and I'm not sure if I want something too hard. The lace is charted, which I've never done before and am intimidated by.

*Circular Shrug*

Pros: Free pattern. Looks fairly quick, opening up the possibility of making two larger things (delusional!) Could possibly add full sleeves.
Cons: No sleeves. Gauge instructions are vague.

Anyone want to help me make up my mind? I'm leaning towards the Midnight Circular. It looks comfy.