Wednesday, May 23, 2012

Scrappy Crochet Bear Pattern

Scrappy Crochet Bear

Supplies
Approximately 9 grams of worsted weight scrap yarn
size G/ 4.25 mm crochet hook
notions to make the face
stuffing
yarn needle

Start with the body, since it is the largest piece.
Body
Ch 60 in body color, work flat in sc until the piece measures about 3.5 inches. This will be the face. Switch to the scraps and continue to sc until the total piece measures 9 inches, changing colors and striping as you wish. Finished piece will measure approx. 14" x 9".

Arms
Ch 20 using the same color as the face. Join into a ring with a slip st and work in sc for half an inch. Switch to using scraps, changing colors and striping s you wish, until the arm measures 3 inches. Make 2.
Legs
Ch 25 (at this point, you may be out of face color. I used the same color to start each leg to give the impression of shoes) Join into a ring with a slip st and work in sc for 1 inch. Switch to your scraps, striping as you wish, until the leg measures 4.5 inches.
Ears
Using whatever colors you have left, Ch 2.
Round 1 - 6 dc into 2nd chain from hook. Join with a slip st into 1st dc.
Round 2 - switch colors, 1 ch, 2 dc into same stitch as chain, {2 dc into next dc} 5 times. Sl st into 1st dc.
Round 3 - switch colors, 1 ch, 2 dc into same stitch as chain, {2 dc into next dc} 10 times. Fasten off and weave in ends.
Finishing and Assembly
For the arms and legs, turn inside out and center the color jogs (think of this as a back seam) Tie off or weave in the ends, press flat and then stitch the end that is the hand or foot closed. Leave the other end open. Lightly stuff the arms and legs.

Add the Face


For the body, find the center of the rectangle and add the face. You can use safety eyes, felt, embroidery floss, whatever you have handy.

Add the Arms


Then fold the edges to the center and mark where the sides are. Lay it out flat again and stitch the arms on (arms should be lightly stuffed).

Add the Legs

Fold right sides together and sew the back seam closed. Center the back seam and then tuck the legs inside the body (legs should already be stuffed), aligning the open edge of the leg with the bottom edge of the body. Pin in place and sew closed.
Turn right side out.

Add Ears and Close
Stuff the body to the desired firmness. Sandwich the first ear between the front and back sides and stitch closed, being careful to pass through all three layers of fabric. Stitch the top middle of the head closed and then add the second ear as the first.

Enjoy your new toy!

1 comment: